Glossy air drying ink intended for printing on polypropylene, frequently encountered as Akilux® and Priplak® brands.
It can adhere to untreated polypropylene (use of bonding primer), but flaming or Corona treatment, when possible, further improves its performance.
The Propylux ink was designed for printing on fluted or sheet polypropylene.
These inks should not be used for printing on thin films (sheaths).
The adhesion primer (ref. 3302070) improves the adherence of Propylux ink on untreated substrates.
This ink can be printed of specific substrate such as dry erase board coated with varnish.
- Appearance: glossy
- Average density: 1,10
- Viscosity: 8 ± 1 Pa.s
– Ambient air: 15 min. at 20°C
– Air jet dryer: 2 min. at 60°C
- Covering power by opacity: good
- Coverage rate: 50 m²/kg with a 120 – 34 mesh
- Weather resistance: poor
- Alcohol resistance: good
- Light fastness: quite good
- Diluents and cleaning solvents:
– Thinner: 4909
– Retarder: propygel or 4900
– Manual: 2881, 2899, NS-81 and NS-99
– Washer: 2899
- Expiry date: refer to the label
|Ref. 1 kg|
|Ref. 1 kg|
|Ref. 1 litre|
|Adhesion primer 3X1189||3302070|
The recommendations for use provided are based on our current knowledge, are given for instructive purposes and are entirely objective. However, as your conditions of use are out of our control, this information would not imply any guarantee on our part. They do not exempt you from carrying out prior tests in order to determine the compatibility of our inks with your printing media within your application conditions. Our responsibility, if it were to be employed, would be limited to the market value of the products that we delivered to you and that you use.